Sony Cyber Shot Dsc H200 Lcd Screen Replacement Repair Guide

Difficulty

Moderate

Steps

9

Time Required

                          15 minutes            

Sections

1

• LCD Screen
• 9 steps

Flags

Slice and Dice

The steps in this guide should be split up and made into a series of prerequisite guides.

• BackSony Cyber-shot DSC-H200

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              LCD Screen               

• Using a screwdriver, remove the five 6mm screws located on the back panel.
• Using a screwdriver, remove the two 3mm screws located on the back panel.

Using a screwdriver, remove the five 6mm screws located on the back panel.

Using a screwdriver, remove the two 3mm screws located on the back panel.

1024

Step 2

• Using a screwdriver, remove one 6mm screw on the front panel.
• Using a screwdriver, remove two 3mm screws on the front panel.

Using a screwdriver, remove one 6mm screw on the front panel.

Using a screwdriver, remove two 3mm screws on the front panel.

Step 3

• Open the SD Door, unscrew and remove the single 6mm screw closest to “PUSH IN/OUT” under the SD card slot.

Open the SD Door, unscrew and remove the single 6mm screw closest to “PUSH IN/OUT” under the SD card slot.

Step 4

• Remove the back panel (the LCD and motherboard are exposed).

Remove the back panel (the LCD and motherboard are exposed).

Step 5

• Using a screwdriver, remove the three 4mm screws that attach the LCD to the camera motherboard. (The LCD is contained in a holding plate, attached to the motherboard with a ribbon cable.)

Using a screwdriver, remove the three 4mm screws that attach the LCD to the camera motherboard. (The LCD is contained in a holding plate, attached to the motherboard with a ribbon cable.)

Step 6

• Using a screwdriver, remove the single 4mm screw at the bottom of the holding plate.

Using a screwdriver, remove the single 4mm screw at the bottom of the holding plate.

Step 7

• Lift the holding plate away from the motherboard and set aside.

Lift the holding plate away from the motherboard and set aside.

Step 8

• Using tweezers, open the LCD ribbon port by lifting the black hinge. (The LCD ribbon cable will detach.)

Using tweezers, open the LCD ribbon port by lifting the black hinge. (The LCD ribbon cable will detach.)

Step 9

• Using tweezers, remove the LCD with the ribbon cable and set aside.

Using tweezers, remove the LCD with the ribbon cable and set aside.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors 

                    Elizabeth Morrison                     

Member since: 04/08/2015

287 Reputation

                                      2 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       Eastern Washington University, Team 2-3, Matresse Spring 2015                        

                                                  Member of Eastern Washington University, Team 2-3, Matresse Spring 2015 



                    EWU-MATRESSE-S15S2G3                     


                                            4 Members                     


                                            10 Guides authored                     

Butch Sullivan - Apr 18, 2018

Reply

Where can you purchase a new replacement monitor?