Sony Cyber Shot Dsc H200 Sd Door Replacement Repair Guide

Difficulty

Moderate

Steps

9

Time Required

                          30 - 35 minutes            

Sections

1

• SD Door
• 9 steps

Flags

Slice and Dice

The steps in this guide should be split up and made into a series of prerequisite guides.

• BackSony Cyber-shot DSC-H200

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              SD Door               

• Using a screwdriver, remove four 6mm screws located on the back panel.

Using a screwdriver, remove four 6mm screws located on the back panel.

1024

Step 2

• Using a screwdriver, remove the two 6mm screws on the bottom.
• Using a screwdriver, remove the four 3mm screws on the bottom.

Using a screwdriver, remove the two 6mm screws on the bottom.

Using a screwdriver, remove the four 3mm screws on the bottom.

Step 3

• Open the SD Door, unscrew and remove the single 6mm screw closest to “PUSH IN/OUT” under the SD card slot.

Open the SD Door, unscrew and remove the single 6mm screw closest to “PUSH IN/OUT” under the SD card slot.

Step 4

• Using the blue plastic opening tools, remove the back panel (the LCD and motherboard are exposed).

Using the blue plastic opening tools, remove the back panel (the LCD and motherboard are exposed).

Step 5

• Using a screwdriver, remove the three 4mm screws that attach the LCD to the camera motherboard (The LCD is contained in a holding plate, attached to the motherboard with a ribbon cable).
• Using the blue plastic opening tool remove the LCD Screen from the motherboard.

Using a screwdriver, remove the three 4mm screws that attach the LCD to the camera motherboard (The LCD is contained in a holding plate, attached to the motherboard with a ribbon cable).

Using the blue plastic opening tool remove the LCD Screen from the motherboard.

Step 6

• Using a screwdriver, remove the single 4mm screw at the bottom of the holding plate.

Using a screwdriver, remove the single 4mm screw at the bottom of the holding plate.

Step 7

• Lift the holding plate away from the motherboard and set aside (the pin attaching the door to the body is now accessible).

Lift the holding plate away from the motherboard and set aside (the pin attaching the door to the body is now accessible).

Step 8

• Using tweezers remove the pin that attaches the door to the body.

Using tweezers remove the pin that attaches the door to the body.

Step 9

• Remove the door.

Remove the door.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 7 other contributors 

                    Elizabeth Morrison                     

Member since: 04/08/2015

287 Reputation

                                      2 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       Eastern Washington University, Team 2-3, Matresse Spring 2015                        

                                                  Member of Eastern Washington University, Team 2-3, Matresse Spring 2015 



                    EWU-MATRESSE-S15S2G3                     


                                            4 Members                     


                                            10 Guides authored