Difficulty
Difficult
Steps
11
Time Required
20 minutes
Sections
3
- Battery
- 2 steps
- Front Cover
- 4 steps
- Back Cover
- 5 steps
Flags
0
BackSony Cyber-shot DSC-TX7
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- The battery compartment is located on the bottom of camera.
- Move the slider from the ’lock’ position to the ‘open’ position.
The battery compartment is located on the bottom of camera.
Move the slider from the ’lock’ position to the ‘open’ position.
1024
Step 2
- Battery not shown.
- Pull battery from compartment.
- Insert newly charged battery into compartment, as shown in diagram (located in compartment).
- Shut compartment door.
- Move the slider back to the ’lock’ position.
Battery not shown.
Pull battery from compartment.
Insert newly charged battery into compartment, as shown in diagram (located in compartment).
Shut compartment door.
Move the slider back to the ’lock’ position.
Step 3
Front Cover
- Use the Phillips #00 screwdriver to remove the 4mm length screws. There are 6 screws total.
Use the Phillips #00 screwdriver to remove the 4mm length screws. There are 6 screws total.
Step 4
- The 4 mm length screws are located on each side and on the bottom of the camera.
- 2 screws on each side (4 total).
- 2 screws on bottom.
The 4 mm length screws are located on each side and on the bottom of the camera.
2 screws on each side (4 total).
2 screws on bottom.
Step 5
- Gently pry around the front cover using the plastic opening tool.
- Carefully separate front cover from body of camera.
Gently pry around the front cover using the plastic opening tool.
Carefully separate front cover from body of camera.
Step 6
- The front cover is now removed from the camera and the internal hardware is now visible.
- They front cover will still be connected by a ribbon. Be careful not to break the ribbon.
The front cover is now removed from the camera and the internal hardware is now visible.
They front cover will still be connected by a ribbon. Be careful not to break the ribbon.
Step 7
Back Cover
- This is the camera with the front cover unscrewed and partially removed.
This is the camera with the front cover unscrewed and partially removed.
Step 8
- Peel the black sticker from the motherboard.
- Locate the connection ribbon between the front cover and the body of the device.
Peel the black sticker from the motherboard.
Locate the connection ribbon between the front cover and the body of the device.
Step 9
- Pull the ribbon out of the connection port so that they are completely disconnected.
Pull the ribbon out of the connection port so that they are completely disconnected.
Step 10
- Use the plastic opening tool to separate the back cover from the inner hardware.
- Continue until back cover can be pulled away from inner hardware.
Use the plastic opening tool to separate the back cover from the inner hardware.
Continue until back cover can be pulled away from inner hardware.
Step 11
- Remove the back cover so that the back cover is now completely separate from the body of the device.
Remove the back cover so that the back cover is now completely separate from the body of the device.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Leslie Mundell
Member since: 03/18/2015
411 Reputation
4 Guides authored
Badges:
6
+3 more badges
Team
Michigan Tech, Team 1-8, Lauer Spring 2015
Member of Michigan Tech, Team 1-8, Lauer Spring 2015
MTU-LAUER-S15S1G8
2 Members
10 Guides authored
