Difficulty

Moderate

Steps

8

Time Required

                          10 - 15 minutes

Sections

3

  • Battery
  • 2 steps
  • Front Cover
  • 4 steps
  • Front Sliding Lens Cover
  • 2 steps

Flags

0

  • BackSony Cyber-shot DSC-TX7

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • The battery compartment is located on the bottom of camera.
  • Move the slider from the ’lock’ position to the ‘open’ position.

The battery compartment is located on the bottom of camera.

Move the slider from the ’lock’ position to the ‘open’ position.

1024

Step 2

  • Battery not shown.
  • Pull battery from compartment.
  • Insert newly charged battery into compartment, as shown in diagram (located in compartment).
  • Shut compartment door.
  • Move the slider back to the ’lock’ position.

Battery not shown.

Pull battery from compartment.

Insert newly charged battery into compartment, as shown in diagram (located in compartment).

Shut compartment door.

Move the slider back to the ’lock’ position.

Step 3

              Front Cover
  • Use the Phillips #00 screwdriver to remove the 4mm length screws. There are 6 screws total.

Use the Phillips #00 screwdriver to remove the 4mm length screws. There are 6 screws total.

Step 4

  • The 4 mm length screws are located on each side and on the bottom of the camera.
  • 2 screws on each side (4 total).
  • 2 screws on bottom.

The 4 mm length screws are located on each side and on the bottom of the camera.

2 screws on each side (4 total).

2 screws on bottom.

Step 5

  • Gently pry around the front cover using the plastic opening tool.
  • Carefully separate front cover from body of camera.

Gently pry around the front cover using the plastic opening tool.

Carefully separate front cover from body of camera.

Step 6

  • The front cover is now removed from the camera and the internal hardware is now visible.
  • They front cover will still be connected by a ribbon. Be careful not to break the ribbon.

The front cover is now removed from the camera and the internal hardware is now visible.

They front cover will still be connected by a ribbon. Be careful not to break the ribbon.

Step 7

              Front Sliding Lens Cover
  • Remove the three 4mm length screws located on the inside of the front cover with the Phillips #00 screwdriver.

Remove the three 4mm length screws located on the inside of the front cover with the Phillips #00 screwdriver.

Step 8

  • Wiggle sliding lens cover after all screws are removed and separate from front cover.

Wiggle sliding lens cover after all screws are removed and separate from front cover.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Leslie Mundell

Member since: 03/18/2015

411 Reputation

                                      4 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       Michigan Tech, Team 1-8, Lauer Spring 2015                        

                                                  Member of Michigan Tech, Team 1-8, Lauer Spring 2015 



                    MTU-LAUER-S15S1G8                     


                                            2 Members                     


                                            10 Guides authored