Difficulty
Moderate
Steps
6
Time Required
10 - 25 minutes
Sections
2
- Prerequisites Only
- 4 steps
- Card Reader
- 2 steps
Flags
1
Action Shots
Be an action hero! This guide needs images that better demonstrate how to perform specific actions.
BackSony Cyber-Shot DSC-TX9
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Prerequisites Only
- Use a Phillips #0 screwdriver to unscrew the six 2mm screws on the outer case of the camera.
- If there is a battery or SD card inside remove before beginning the process.
Use a Phillips #0 screwdriver to unscrew the six 2mm screws on the outer case of the camera.
If there is a battery or SD card inside remove before beginning the process.
1024
Step 2
- Use your hands or a Spudger to Pull off the front cover of the camera.
- If the casing is not coming apart easily, do not force it.
Use your hands or a Spudger to Pull off the front cover of the camera.
If the casing is not coming apart easily, do not force it.
Step 3
- Remove the protective black cover layer with your hands and set it aside.
- The use of tweezers may be necessary if the cover is difficult to remove.
Remove the protective black cover layer with your hands and set it aside.
The use of tweezers may be necessary if the cover is difficult to remove.
Step 4
- The ZIF connector can be removed by flipping the small black holder into the upright position and then sliding the ribbon cable out carefully.
- Once this has been done, use tweezers to unplug the flat topped connector for the lens’ circuit board from the motherboard.
- DO NOT force the ribbon cables or they will rip.
- Refer to the (Recognizing & Disconnecting Cable Connectors) page for assistance.
The ZIF connector can be removed by flipping the small black holder into the upright position and then sliding the ribbon cable out carefully.
Once this has been done, use tweezers to unplug the flat topped connector for the lens’ circuit board from the motherboard.
DO NOT force the ribbon cables or they will rip.
Refer to the (Recognizing & Disconnecting Cable Connectors) page for assistance.
Step 5
Card Reader
- Using a Phillips head screw driver, remove the two screws for the metal plate on the bottom.
- Detach the smaller ribbon cables by sliding them out.
- Detach the large ribbon cable by flipping the small black holder in an upright position and then sliding the cable out carefully.
- Detach the ribbon cables slowly and carefully or they will rip.
Using a Phillips head screw driver, remove the two screws for the metal plate on the bottom.
Detach the smaller ribbon cables by sliding them out.
Detach the large ribbon cable by flipping the small black holder in an upright position and then sliding the cable out carefully.
Detach the ribbon cables slowly and carefully or they will rip.
Step 6
- Carefully remove the Memory card circuit board.
- The circuit board should come out with little force. If it does not, make sure all connections are disconnected.
Carefully remove the Memory card circuit board.
The circuit board should come out with little force. If it does not, make sure all connections are disconnected.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Yegor Shea
Member since: 03/26/2017
301 Reputation
3 Guides authored
Badges:
6
+3 more badges
Team
UMass Dartmouth, Team S4-G3, Julie Spring 2017
Member of UMass Dartmouth, Team S4-G3, Julie Spring 2017
UMASSD-JULIE-S17S4G3
5 Members
8 Guides authored
